Parts list

Use the parts list to identify each of the components that are available for your server.

For more information about ordering the parts shown in the Figure 1:

Note

Depending on the model, your server might look slightly different from the illustration.

The parts listed in the following table are identified as one of the following:

Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.
Tier 2 customer replaceable unit (CRU): You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.
Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.
Consumable and Structural parts: Purchase and replacement of consumable and structural parts (components, such as a cover or bezel) is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.

Server components

Figure 1. Server components

Table 1. Parts listing .
Index	Description	Tier 1 CRU	Tier 2 CRU	FRU	Consumable and Structural part
For more information about ordering the parts shown in Figure 1: Parts list
`1`	Top cover				√
`2`	Air baffle				√
`3`	Fan	√
`4`	Intrusion switch cable	√
`5`	Screwdriver in Misc kit				√
`6`	Intrusion switch	√
`7`	LTE Antenna	√
`8`	WLAN Antenna	√
`9`	M.2 WLAN/LTE module cable			√
`10`	Processor heat sink			√
`11`	Power adapter	√
`12`	CMOS battery (CR2032)				√
`13`	System board			√
`14`	12 V power distribution module		√
`15`	-48 V power distribution module		√
`16`	DIMM	√
`17`	M.2 boot adapter		√
`18`	10G SFP⁺ LOM package chassis				√
`19`	Wireless enabled LOM package chassis				√
`20`	Front operator panel				√
`21`	M.2 WLAN/LTE wireless adapter			√
`22`	M.2 LTE module			√
`23`	M.2 WLAN module			√
`24`	10G SFP⁺ LOM package				√
`25`	10G BASE-T LOM Package				√
`26`	Wireless enabled LOM package				√
`27`	Locking cable	√
`28`	Front filler				√
`29`	M.2 riser assembly		√
`30`	PCIe and M.2 riser assembly		√
`31`	M.2 SATA/NVMe data adapter		√
`32`	M.2 SATA/NVMe heat sink				√
`33`	PCIe adapter		√

Give documentation feedback