Remove an EDSFF hot-swap drive

Use this information to remove a EDSFF hot-swap drive.

About this task

Attention

• Read Safety inspection checklist and Installation Guidelines to ensure that you work safely.

• If one or more EDSFF drives are to be removed, it is recommended to disable them beforehand via the operating system.

• Before you make changes to the drives, drive controllers, drive backplanes, or drive cables, make sure to back up all important data stored in drives.

• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration information.

• Make sure you have the drive bay filler available if no EDSFF drives are going to be installed after the removal.

Important

Only touch and hold the EDSFF drive handle when removing EDSFF drive from the compute node. EDSFF drive may be damaged if you touch parts other than the handle before the EDSFF drive is completely removed out of the compute node.

Figure 1. EDSFF drive handle

Table 1. EDSFF drive handle

1 EDSFF drive handle

Procedure

1. Make a note of the number of the drive bay from which your are removing the drive. Drives must be installed in the bay from which they were removed.
2. Hold the handle of the EDSFF drive cage bezel and pull it out of the compute node to access the EDSFF drives.
   Figure 2. EDSFF drive cage bezel removal
   
   
3. Remove the EDSFF hot-swap drive.
   1. Slightly press down the handle on the EDSFF drive.
   2. Rotate the handle to the open position.
   3. Hold the handle to remove the drive out of the drive bay.
   Attention

   Only touch and hold the EDSFF drive handle when removing EDSFF drive from the compute node. EDSFF drive may be damaged if you touch parts other than the handle before the EDSFF drive is completely removed out of the compute node.

   Figure 3. EDSFF hot-swap drive removal