Skip to main content

Remove the flash power module

Use this information to remove the flash power module.

Before you remove the flash power module, complete the following steps:

  1. Read Installation Guidelines to ensure that you work safely.

  2. Power off the corresponding compute node that you are going to perform the task on.

  3. Remove the compute node from the chassis (see Remove the compute node from the chassis).

  4. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.

  5. Remove the compute node cover (see Remove the compute node cover).

Note
This section only applies to RAID adapters that come with a flash power module.

To remove the flash power module, complete the following steps:

Figure 1. Flash power module removal
Flash power module removal

  1. Remove the RAID adapter (see Remove a RAID adapter ).
  2. Carefully turn the RAID adapter over in your hand to access the underside. Press down on the rear of the flash power module; then, slide the flash power module out of its holder on the RAID adapter.
  3. Disconnect the flash power module cable from the RAID adapter.
    Attention
    To prevent any damage to the flash power module cable or connector, it is important to first slide out the flash power module. This provides more space for your fingers to better grip the flash power module cable and remove it from the connector.

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube