Parts list

Use the parts list to identify each of the components that are available for your server.

For more information about ordering the parts shown in Figure 1, go to:

Note

Depending on the model, your server might look slightly different from the following illustration. Some of the components might not be available on your server.

Figure 1. Server components

Graphic showing all parts associated with the server

The parts listed in the following table are identified as one of the following:

Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.
Tier 2 customer replaceable unit (CRU): You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.
Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.
Consumable and Structural parts: Purchase and replacement of consumable and structural parts (components, such as a cover or bezel) is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.

Table 1. Parts list
Index	Description	Tier 1 CRU	FRU	Consumable and Structural parts
For more information about ordering the parts shown in Figure 1, go to: Parts list
`1`	Top cover	√
`2`	Air baffle			√
`3`	RAID super capacitor module	√
`4`	Heat sink		√
`5`	Processor		√
`6`	Hot-swap power supply	√
`7`	Backplane, eight 2.5-inch hot-swap drives	√
`8`	Backplane, twelve 3.5-inch hot-swap drives	√
`9`	Backplane, eight 3.5-inch hot-swap drives	√
`10`	Simple-swap-drive backplate assembly	√
`11`	Security bezel	√
`12`	Right rack latch, with front I/O assembly	√
`13`	Left rack latch, with VGA connector	√
`14`	Right rack latch, without front I/O assembly			√
`15`	Left rack latch, without VGA connector			√
`16`	Chassis		√
`17`	2.5-inch hot-swap drive filler			√
`18`	2.5-inch hot-swap drive	√
`19`	3.5-inch drive filler			√
`20`	3.5-inch simple-swap drive	√
`21`	3.5-inch hot-swap drive	√
`22`	Front I/O assembly, server models with eight or sixteen 2.5-inch drive bays	√
`23`	Front I/O assembly, server models with eight 3.5-inch drive bays	√
`24`	System board		√
`25`	CMOS battery (CR2032)			√
`26`	System fan	√
`27`	DIMM	√
`28`	M.2 drive	√
`29`	M.2 retainer	√
`30`	M.2 backplane	√
`31`	Riser 1 bracket	√
`32`	Riser 2 bracket	√
`33`	Riser card	√
`34`	PCIe adapter	√
`35`	TCM/TPM adapter (for Chinese Mainland only)		√

Give documentation feedback