Install the LOM adapter

Use this information to install the LOM adapter.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

Before installing the LOM adapter:

• If the server comes with a LOM adapter slot bracket, remove it with a tool first. Store the bracket in case that you later remove the LOM adapter and need the bracket to cover the place.

  CAUTION

  Use a tool to remove the LOM adapter slot bracket to avoid injury.

• Touch the static-protective package that contains the new LOM adapter to any unpainted surface on the outside of the server. Then, take the new LOM adapter out of the package and place it on a static-protective surface.

To install the LOM adapter, complete the following steps:

Watch the procedure

A video of this procedure is available at YouTube.

Figure 1. LOM adapter installation

1. Place the LOM adapter into the connector on an angle.
2. Rotate the LOM adapter down.
3. Push the LOM adapter as shown to insert it into the connector on the system board.
4. Tighten the thumbscrew to secure the LOM adapter.