Skip to main content

Remove the system board

Use this information to remove the system board.

Read the installation GuidelinesPower off the server for this taskATTENTION: Static Sensitive Device Ground package before opening
Before removing the system board:

  1. Remove the top cover. See Remove the top cover.

  2. Remove the air baffle. See Remove the air baffle.

  3. Record where the cables are connected to the system board; then, disconnect all the cables.
    Attention
    Disengage all latches, cable clips, release tabs, or locks on cable connectors beforehand. Failing to release them before removing the cables will damage the cable connectors on the system board. Any damage to the cable connectors may require replacing the system board.
  4. Remove any of the following components that are installed on the system board and put them in a safe, static-protective place. See the related topics in this chapter.

    • System fans

    • Processor-heat-sink module (PHM)
      Note
      Do not disassemble the PHM.

    • DIMMs

    • LOM adapter

    • M.2 backplane

    • Riser assemblies

    • CMOS battery

    • TCM (only available in Chinese Mainland)

  5. Pull out the power supplies slightly. Ensure that they are disconnected from the system board.

  6. Remove the cable holder.
    Figure 1. Cable holder removal
    Cable holder removal

To remove the system board, complete the following steps:

Watch the procedure

A video of this procedure is available at YouTube.

Figure 2. System board removal
System board removal

  1. Remove the eight screws that secure the system board, and put the screws in a safe place.
  2. Hold the blue lift handles on the system board, slightly pull the system board towards the front of the server, and lift the system board upwards. Then, remove the system board from the server carefully.
If you are instructed to return the old system board, follow all packaging instructions and use any packaging materials that are provided.
Important
Before you return the system board, make sure that you install the CPU socket dust covers from the new system board. To replace a CPU socket dust cover:

  1. Take a dust cover from the CPU socket assembly on the new system board and orient it correctly above the CPU socket assembly on the removed system board.

  2. Gently press down the dust cover legs to the CPU socket assembly, pressing on the edges to avoid damage to the socket pins. You might hear a click on the dust cover is securely attached.

  3. Make sure that the dust cover is securely attached to the CPU socket assembly.