Skip to main content

Top view

This section contains information on the top view of the server.

The following illustrations show the top views of the server without any air baffle or rear cage installed.

Top view of 2.5-inch drive configuration

Figure 1. Top view of 2.5-inch drive configuration
Top view of 2.5-inch drive configuration

Table 1. Components on the top view of 2.5-inch drive configuration
1 Power supply units7 M.2 drive module
2 Processors8 Intrusion switch
3 Fan modules9 Memory modules
4 Internal RAID adapter10 System board assembly
5 Front backplane11 Riser assemblies
6 RAID flash power module 
Note
  1. The illustration shows the server rear configuration with three riser assemblies. The server rear configurations vary by server model. For details, see Rear view.

  2. The illustration shows the location of certain parts. Some parts may not be supported at the same time within certain configuration(s).

Top view of a server with the liquid assisted cooling module installed

The illustration below singles out the Liquid Assisted Cooling Module (LACM) from other components in the chassis. The parts contained depend on the configuration of the server.

Figure 2. Top view of the LACM

Table 2. Components on the top view of the LACM
1 Liquid detection sensor module4 Radiator
2 The holder for the liquid detection sensor module5 The holder for the radiator
3 Cold plate assembly