Skip to main content

Install the 2.5-inch drive backplane

Follow instructions in this section to install the 2.5-inch drive backplane.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Touch the static-protective package that contains the drive to any unpainted metal surface on the server; then, remove the drive from the package and place it on a static-protective surface.

Procedure

  1. Position the 2.5-inch drive backplane and the backplane module as illustrated below. Align the square-shape guide slot on the drive backplane to the square-shape guide pin on backplane module, and align the screw holes on backplane and the backplane module. Then, insert the backplane into the backplane module.
    Note
    Make sure the backplane and backplane module position is arranged as illustrated below.
    Figure 1. Inserting the 2.5-inch drive backplane into the module
    Inserting the 2.5-inch drive backplane into the module
  2. Hold the backplane and the backplane module together; then, turn them over as illustrated below. Fasten the two screws to secure the backplane to the backplane module.
    Figure 2. Installing the 2.5-inch drive backplane to the module
    Installing the 2.5-inch drive backplane to the module
After you finish

Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube