Install a flash power module
Follow instructions in this section to install a flash power module.
About this task
Attention
Go over Installation Guidelines to ensure that you work safely.
Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.
Procedure
Install the flash power module.
Figure 1. Installing the flash power module into a horizontal holder
Figure 2. Installing the flash power module into the vertical holder
Press and release the retaining latch.
Align the flash power module with the holder hinge.
Rotate the other end of the module inward until it is secured in the holder.
Close the retaining latch.
After this task is completed
Install the PCIe riser assembly (see Install the PCIe riser assembly).
Connect the cable to the corresponding RAID adapters.
Proceed to complete the parts replacement (see Complete the parts replacement).
Demo video
Give documentation feedback