Skip to main content

Install the USB front panel module

Follow instructions in this section to install the USB front panel module.

About this task

Attention

  • Go over Installation Guidelines to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Align the USB front panel module with the bay on the front of the server, and slide it towards the front of the server until it clicks in place.
    Figure 1. Installing the USB front panel module


    Note
    Make sure to route the cable through the cable clips as illustrated.
  2. Route the USB front panel cable through the side cable guide, and connect it to the system board.
    Figure 2. Connecting the USB front panel cable

After this task is completed

Proceed to complete the parts replacement (see Complete the parts replacement).

Demo video

Watch the procedure on YouTube