Install the intrusion switch

Use this information to install the intrusion switch.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

Before installing the intrusion switch:

1. Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

1. Insert the cable of the new intrusion switch and then the tab on the intrusion switch frame into the corresponding hole in the chassis. Then, push the intrusion switch in until it is securely seated.
   Figure 1. Installing the intrusion switch
   
   
2. Connect the cable of the new intrusion switch to Chassis intrusion switch connector on the system board. See System board components.