Skip to main content

Install the heat sink and the fan module

Follow this procedure to install the heat sink and the fan module. This procedure must be executed by a trained technician.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Before installing the heat sink and the fan module:
  1. Install the processor if one is not yet installed (see Install the processor).

  2. If you are installing a replacement heat sink and fan module, remove the frame.

    Figure 1. Removing the frame
    Removing the frame
  3. Install the frame to the bottom of the system board if necessary.

    Figure 2. Installing the frame
    Installing the frame

To install the heat sink and the fan module, complete the following steps:

  1. Align the four screws on the heat sink and fan assembly with the corresponding screw holes on the system board. Make sure the fan cable is close to the heat sink fan connector (See Cable routing for the fans).
    Figure 3. Aligning the heat sink and fan module
    Aligning the heat sink and fan module
  2. Tighten screw 1 and 2:
    1. Partially tighten screw 1.
    2. Fully tighten screw 2.
    3. Fully tighten screw 1.
    Figure 4. Installing the heat sink and the fan module
    Installing the heat sink and the fan module
  3. Tighten screw 3 and 4:
    1. Partially tighten screw 3.
    2. Fully tighten screw 4.
    3. Fully tighten screw 3.
  4. Connect the fan cable to the system board.
After installing the heat sink and the fan module:
  1. Install the system board (see Install the system board (trained technician only)).

  2. Proceed to complete the parts replacement (see Complete the parts replacement).

Demo video

Watch the procedure on YouTube