Remove the thermal sensor

Follow this procedure to remove the thermal sensor.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Before removing the thermal sensor:

1. Read the safety information and installation guidelines (see Safety and Installation guidelines).

2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables (see Power off the server).

3. If the server is in a rack, remove it from the rack.

4. Remove any locking device that secures the server cover, such as a Kensington lock or a pad lock.

5. Remove the server cover (see Remove the server cover).

   CAUTION

   The heat sinks and processor could be very hot. To avoid from burning yourself, wait for a few minutes after turning off the server before you remove the server cover.

6. Remove the front bezel (see Remove the front bezel).

To remove the thermal sensor, complete the following steps:

1. Disconnect the thermal sensor cable from the system board.
   Note

   Follow the instructions in Internal cable routing and handle the release tab on the connector carefully.

2. Press the retaining clip on the top of the thermal sensor, and pull to remove the sensor from the chassis.
   Figure 1. Removing the thermal sensor