Skip to main content

Installing flash power module holder

Note
The RAID adapter battery or flash power module holder is supported on the 2.5-inch-drive server models only.

To install flash power module holder, do the following:

  1. Turn off the server. Then, disconnect all external cables and remove all peripheral devices.
  2. Remove the server cover. See Removing the server cover.
  3. Place the holder on the chassis as shown and align the screw holes in the holder with the ones in the chassis. Then, install the two screws and make sure that the holder is secured firmly on the chassis.
    Figure 1. Flash power module holder installation
    Flash power module holder installation

  4. Install a flash power module. See Installing a RAID adapter battery or flash power module.
  5. Complete the parts replacement. See Completing the parts replacement.