Removing and installing Tier 1 CRUs
Installation of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request, you will be charged.
The illustrations in this document might differ slightly from your hardware.
- Removing a DIMM
- DIMM installation guidelines
The following tips describe the types of DIMMs that the server supports and other information that you must consider when you install DIMMs. - Installing a DIMM
- Removing a hot-swap hard disk drive
- Installing a hot-swap hard disk drive
- Removing a simple-swap hard disk drive
- Installing a simple-swap hard disk drive
- Removing the optical drive
- Installing the optical drive
- Removing an adapter
- Installing an adapter
- Removing a ServeRAID SAS/SATA controller memory module
- Installing a ServeRAID SAS/SATA controller memory module
- Removing a RAID adapter battery or flash power module
- Installing a RAID adapter battery or flash power module
- Removing a USB embedded hypervisor flash device
- Installing a USB embedded hypervisor flash device
- Removing the front I/O assembly
- Installing the front I/O assembly
- Removing the operating temperature enhancement kit
- Installing the operating temperature enhancement kit
- Removing a system fan
- Installing a system fan
- Removing the coin-cell battery
- Installing the coin-cell battery
- Removing the fixed power supply
- Installing the fixed power supply
- Removing a hot-swap power supply
- Installing a hot-swap power supply
- Removing the PCI riser card from the PCI riser-card assembly
- Installing the PCI riser card to the PCI riser-card assembly
- Removing the 2.5-inch hot-swap hard-disk-drive backplane
- Installing the 2.5-inch hot-swap hard-disk-drive backplane
- Removing the 2.5-inch simple-swap hard-disk-drive backplate assembly
- Installing the 2.5-inch simple-swap hard-disk-drive backplate assembly
- Removing the 3.5-inch hot-swap hard-disk-drive backplane
- Installing the 3.5-inch hot-swap hard-disk-drive backplane
- Removing the 3.5-inch simple-swap hard-disk-drive backplate assembly
- Installing the 3.5-inch simple-swap hard-disk-drive backplate assembly
Give documentation feedback