Skip to main content

Installing the operating temperature enhancement kit

To install the operating temperature enhancement kit, do the following:

  1. Turn off the server. Then, disconnect all external cables and remove all peripheral devices.
  2. Remove the server cover. See Removing the server cover.
  3. Remove the PCI riser-card assembly. See Removing the PCI riser-card assembly.
  4. Connect the operating temperature enhancement kit connector to the system board.
  5. Route the cable along the chassis. Make sure the relevant cables pass through the cable clips.
    Figure 1. Operating temperature enhancement kit cable connection for 2.5-inch-drive model
    Operating temperature enhancement kit cable connection for 2.5-inch-drive model

    Figure 2. Operating temperature enhancement kit cable connection for 3.5-inch-drive model
    Operating temperature enhancement kit cable connection for 3.5-inch-drive model

    Attention
    Make sure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.
  6. Slide the operating temperature enhancement kit 1 into the slot 2 on the hard disk drive cage until the operating temperature enhancement kit locks into place with an audible click.
    Figure 3. Operating temperature enhancement kit installation
    Operating temperature enhancement kit installation

  7. Complete the parts replacement. See Completing the parts replacement.