Skip to main content

Serial-device problems

Two column table for documenting the symptom and the corresponding action for serial-device problems.

  • Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
  • See Parts listing to check if a component is a consumable, structural, or FRU part.
  • If an action step is preceded by (Trained technician only), that step must be performed only by a trained technician.
SymptomAction
The number of serial ports that are identified by the operating system is less than the number of installed serial ports.
  1. Make sure that:
    • Each port is assigned a unique address in the Setup utility and none of the serial ports is disabled.
    • The serial-port adapter (if one is present) is seated correctly.
  2. Reseat the serial port adapter.
  3. Replace the serial port adapter.
A serial device does not work.
  1. Make sure that:
    • The device is compatible with the server.
    • The serial port is enabled and is assigned a unique address.
    • The device is connected to the correct connector (see Rear view).
  2. Reseat the following components:
    1. Failing serial device
    2. Serial cable
  3. Replace the components listed in step 2 one at a time, in the order shown, restarting the server each time.
  4. (Trained technician only) Replace the system board.