Installing the ServeRAID adapter memory module

Use this information to install the ServeRAID adapter memory module.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see Removing the cover).
4. Connect the cable to the ServeRAID adapter memory module.
   Figure 1. Cable installation
   
   
5. Align the memory module with the retention pins. Install the memory module into the system board.
   Figure 2. ServeRAID adapter memory module installation
   
   
6. Connect the other end of the cable to the flash power module.
   Figure 3. Cable installation
   
   

   Note

   Make sure the flash power module is seated properly (see Installing a RAID adapter battery or flash power module).