Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see Removing the cover).
4. Remove PCI riser-card assembly 2 (see Removing a PCI riser-card assembly).
5. Install the flash device:
   Figure 1. USB hypervisor flash device installation
   
   
   1. Align the flash device with the connector on the system board and push it into the USB connector until it is firmly seated.
   2. Slightly pull up on the blue lockbar to lock the flash device into the USB connector.