Skip to main content

Removing a RAID adapter battery or flash power module

Use this information to remove a RAID adapter battery or flash power module.

If a RAID adapter battery or flash power module is installed near the fan cage and you need to replace it, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect all power cords.
  3. Remove the cover (see Removing the cover).
  4. Push the tab to open the cover on top of the air baffle.
    Figure 1. Cover open
    Cover open
  5. Lift the battery or flash power module up to remove it from the holder.
    Figure 2. RAID adapter battery or flash power module removal
    RAID adapter battery or flash power module removal
    Attention
    Make sure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.
  6. Disconnect the cable from the battery.
    Note
    You don't have to disconnect the cable from the flash power module.

If you are instructed to return the RAID adapter battery or flash power module, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.