Replacing the bezel

Use this information to replace the bezel.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables, if necessary.
3. Reinstall the operator information panel assembly in the bezel, if it has been removed earlier (see Replacing the operator information panel assembly).
4. Insert the tabs on the bottom of the bezel into the slots on the underside of the chassis and attach it with the screws.
   Note

   Use the hex screw driver to install the screws.

   Figure 1. Bezel installation
   
   
5. Connect any cables you previously removed from the front of the server.