Skip to main content

Replacing the media cage

Use this information to replace the media cage.

To install the media cage (also known as the front I/O cage), complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Carefully push the media cage back into the server; then reconnect the cables that were removed from the system board. This may include the front USB connector assembly, front video connector assembly, operator information panel assembly, or LCD operating panel assembly cables. Remember to insert the cables into the relevant cable clips and cable tie.
    Note
    Remember the cable routing before disconnecting the cables from the system board.
    Figure 1. Media cage installation
    Media cage installation
  3. Reinstall the air baffle (see Replacing the air baffle).
  4. Reinstall the cover (see Replacing the cover).
  5. Slide the server into the rack.
  6. Reconnect the power cords and any cables that you removed.
  7. Turn on the peripheral devices and the server.