Skip to main content

Configuring access control

Use the information in this topic to view or change IMM2 access control settings.

Click the Access Control tab to view or modify IMM2 access control settings.

To use access control, complete the following fields:
List of Blocked IP address
If the checkbox of “Blacklist of IP Addresses” is ticked, one textbox will be shown. Users could enter no more than three IPv4 addresses or ranges which are not allowed to access this IMM. And users must use comma to split them. The formats of IPv4 addresses and ranges are:
  1. The single IPv4 address. For example: 192.168.1.1
  2. The supernet IPv4 address. For example: 192.168.1.0/24
  3. The IPv4 range. For example: 192.168.1.1-192.168.1.5
List of Blocked MAC address
If the checkbox of “Blacklist of MAC Addresses” is checked, one textbox will be shown. Users could enter no more than three MAC addresses which are not allowed to access this IMM. And users must use comma to split them. The format of MAC addresses is the single MAC address. For example: 11:22:33:44:55:66.
Restricted Access (one time)
You can schedule a one-time time interval during which the XClarity Controller cannot be accessed. For the time interval that you specify:
  • The beginning date and time must be later than the current XCC time.
  • The ending date and time must be later than the beginning date and time.

The following illustration shows the Access Control tab.

access control