OCP module cable routing
Follow instructions in this section to install and route the cables for the OCP module.
Note
Connections between connectors; 1↔1, 2↔2, 3↔3, ... n↔n
When routing the cables, make sure that all cables are routed appropriately through the corresponding cable guides and cable clips.
Figure 1. OCP module cable routing
From (Rear OCP) | To (System board) | Cable length |
---|---|---|
1 Rear OCP slot (secured with screws) | 1a OCP sideband connector | 350/355/370 mm |
1b OCP signal connector 1 | ||
1c OCP signal connector 2 |
Give documentation feedback