Rear I/O module cable routing
Follow instructions in this section to install and route the cables for the rear I/O module.
Note
- Connections between connectors; 1↔1, 2↔2, 3↔3, ... n↔n
- When routing the cables, make sure that all cables are routed appropriately through the corresponding cable guides and cable clips.
Attention
When routing cables, ensure that the rear I/O cable is not lying on top of the PDB power cable at its connector area.
Figure 1. Rear I/O module cable routing
| From (Rear I/O module) | To (System board) | Cable length |
|---|---|---|
| 1 Rear I/O signal connector (on rear I/O module) | 1a Rear I/O USB DP connector | 750/495 mm |
| 1b Rear I/O Ethernet connector |
Give documentation feedback