Skip to main content

Node front view

This section contains information on the controls and connectors on the front of the ThinkSystem SD530 V3 node. Depending on the specific configuration, some of the components or connectors might not be supported.

Front view of the SD530 V3 node​

See the following illustration for components and connectors on the front of the ThinkSystem SD530 V3 node.

Figure 1. Front view of the ThinkSystem SD530 V3 node
Configuration with E3.S drive
Table 1. Components on the front of the ThinkSystem SD530 V3 node
1E3.S drive bay6External diagnostic handset connector
2Drive activity LED7Front operator panel buttons and LEDs
3Drive status LED8USB 3.2 Gen 1 (5 Gbps) connector
4Pull-out information tab9VGA connector
5Serial connector

 

1 E3.S drive bays​

2 & 3 Drive activity LED & Drive status LED​

4 Pull-out information tab​

This tab contains below information:

  • Network information such as MAC address and XCC network access label.

  • Drive bay numbers.

For more information about this tab, see Identify the system and access the Lenovo XClarity Controller.

5 Serial connector​

Connect a 9-pin serial device to this connector.

6 External diagnostic handset connector​

Connect the external diagnostics handset to this connector.

For more details, see External Diagnostics Handset.

7 Front operator panel buttons and LEDs​

For more information about the front operator panel buttons and LEDs, see Front operator panel LEDs.

8 USB 3.2 Gen 1 (5 Gbps) connector​

Connect a USB device, such as a mouse, keyboard, or other devices, to this connector.

9 VGA connector​

Connect a monitor to this connector.

Note

The maximum video resolution is 1920 x 1200 at 60 Hz.

Back to top