Skip to main content

Complete the parts replacement

Go through the checklist to complete parts replacement

To complete the parts replacement, do the following:

  1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left inside your server.

  2. Properly route and secure the cables in the server. Refer to the cable connecting and routing information for each component.

  3. If applicable, reinstall the expansion filler or expansion kit.

  4. If applicable, reinstall the desktop mount fan shroud. See Install the desktop mount fan shroud.

  5. If necessary, reinstall the node to the enclosure or mount. See Configuration guide.

  6. Reconnect the power cords and any cables that you removed.

    Note
    To connect the power cords, see the Power adapter replacement.

  7. Install the I/O fillers when the connectors are not used. The connectors could be dust-covered without proper protection of the fillers. See Front I/O fillers and Rear I/O fillers.

  8. If the Security LED of the server is blinking, activate or unlock the system. See Activate or unlock the system.

  9. Power on the server and any peripheral devices. See Power on the server.

  10. Update the server configuration.