Skip to main content

Install a CMOS battery (CR2032)

Follow instructions in this section to install a CMOS battery (CR2032).

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
S004
Attention
CAUTION

When replacing the lithium battery, use only Lenovo specified part number or an equivalent type of battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.

Do not:
  • Throw or immerse into water
  • Heat to more than 100°C (212°F)
  • Repair or disassemble

Dispose of the battery as required by local ordinances or regulations.

S005
Attention
CAUTION
The battery is a lithium ion battery. To avoid possible explosion, do not burn the battery. Exchange it only with the approved part. Recycle or discard the battery as instructed by local regulations.
Consider the following when replacing the CMOS battery.
  • Lenovo has designed this product with user safety in mind. The lithium battery must be handled properly to avoid potential danger. Make sure to follow instructions in this topic while replacing the battery.
  • The CMOS battery must be replaced with another unit of the same type (CR2032).
  • For high temperature operation environment, it is recommended to use CR2032HR instead.
  • After replacement is completed, it is required to reconfigure the server and reset the system date and time.
  • Dispose of the CMOS battery as required by local ordinances or regulations.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

  • To avoid potential damage, do not let the CMOS battery contact any metal surface.

  • Make sure that all the server power cords are disconnected from power source before performing this procedure.

Procedure

  1. Follow any special handling and installation instructions that come with the CMOS battery.
  2. Locate the CMOS battery socket on the system board.
    Figure 1. CMOS battery locations on the system board

    1 3V system battery2 3V security battery
    Note

    If 3V security battery is replaced, the system enters System Lockdown Mode and needs to be activated or unlocked. See Activate or unlock the system.

  3. Install the CMOS battery.
    1. Place the CMOS battery on top of the socket with the positive (+) symbol facing up.
    2. Press the battery into the seat until it clicks in place.
    Figure 2. Installing the CMOS battery

After this task is completed

  1. Complete the parts replacement. See Complete the parts replacement.

  2. If 3V security battery is replaced, the system enters System Lockdown Mode and needs to be activated or unlocked. See Activate or unlock the system.

  3. Power on the server; then, reset date, time, and all the passwords.

Demo Video

Watch the procedure on YouTube