Install the intrusion switch with cable

See this topic to learn how to install the intrusion switch with cable.

1. Make sure the power backplane sideband cable is disengaged from the cable clip. If not, disengage it from the cable clip.
   Figure 1. Cable routing for the power backplane and the intrusion switch
   
   

   Table 1. Cable routing for the power backplane and the intrusion switch

   	From	To
   1 Intrusion switch cable	Intrusion switch	Intrusion switch connector
   2 Power backplane sideband cable	Power backplane	Power backplane sideband connector

2. Align the intrusion switch with the guide slot and shoulder pin on the chassis; then, secure the intrusion switch with a screw.
   Figure 2. Installing the intrusion switch with cable
   
   
3. Route the intrusion switch with cable through the cable clip, and connect it to the connector on the system board.
4. Secure the power backplane sideband cable in the cable clip.
   Figure 3. Cable routing for the power backplane and the intrusion switch
   
   

   Table 2. Cable routing for the power backplane and the intrusion switch

   	From	To
   1 Intrusion switch cable	Intrusion switch	Intrusion switch connector
   2 Power backplane sideband cable	Power backplane	Power backplane sideband connector