Install the bulkhead
Use this information to install the bulkhead.
Before you install the bulkhead:
Read Installation Guidelines to ensure that you work safely.
To install the bulkhead, complete the following steps:
Figure 1. Bulkhead installation
- Carefully place the compute node to the up-side-down orientation.
- Align the bulkhead to the rear end of the compute node.
- Using a T8 Torx screwdriver, install the screws that secure the bulkhead to the bottom of the compute node.
- Using a T8 Torx screwdriver, install the screws that secure the bulkhead to the sides of the compute node.
- Carefully return the node to the bottom-side-down orientation.
After you install the bulkhead, complete the following steps:
- Install the I/O expansion adapters (see Install an I/O expansion adapter
- Install the fabric connector (see Install a fabric connector).
- Install the air baffle (see Install the air baffle).
Install the compute node cover (see Install the compute node cover ).
Install the compute node into the chassis (see Install the compute node in the chassis ).
Power on the compute node.
Demo video
Give documentation feedback