Parts list

Use the parts list to identify each of the components that are available for your server.

For more information about ordering the parts shown in Figure 1, go to:

Note

Depending on the model, your server might look slightly different from the illustration. Some of the components might not be available on your server.

Figure 1. Server components

Graphic showing all parts associated with the server

The parts listed in the following table are identified as one of the following:

Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.
Tier 2 customer replaceable unit (CRU): You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.
Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.
Consumable and Structural parts: Purchase and replacement of consumable and structural parts (components, such as a cover or bezel) is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.

Table 1. Parts list
Index	Description	Tier 1 CRU	FRU	Consumable and Structural parts
For more information about ordering parts, go to: Parts list
`1`	Top cover	√
`2`	Air baffle			√
`3`	LOM adapter	√
`4`	Riser 1 bracket (two low-profile slots)	√
`5`	Riser 2 bracket (one low-profile slot)	√
`6`	Riser 1 bracket (one low-profile slot and one full-height half-length slot)	√
`7`	Serial port module	√
`8`	Riser card	√
`9`	TCM/TPM adapter (for Chinese Mainland only)		√
`10`	System board		√
`11`	M.2 drive backplane	√
`12`	M.2 retainer	√
`13`	M.2 drive	√
`14`	RAID super capacitor module	√
`15`	Power supply	√
`16`	Power supply filler			√
`17`	PCIe adapter	√
`18`	Security bezel	√
`19`	Chassis with four 3.5-inch drive baysChassis with eight 2.5-inch drive baysChassis with ten 2.5-inch drive bays		√
`20`	Front I/O assembly for server models with four 3.5-inch drive bays	√
`21`	Front I/O assembly for server models with eight 2.5-inch drive bays	√
`22`	Front I/O assembly for server models with ten 2.5-inch drive bays	√
`23`	2.5-inch drive filler			√
`24`	2.5-inch hot-swap drive	√
`25`	3.5-inch drive filler			√
`26`	3.5-inch hot-swap drive	√
`27`	3.5-inch simple-swap drive	√
`28`	System fan (for server models with ten 2.5-inch drive bays)	√
`29`	System fan (for server models with four 3.5-inch drive bays and server models with eight 2.5-inch drive bays)	√
`30`	CMOS battery (CR2032)			√
`31`	Backplane for ten 2.5-inch hot-swap drives	√
`32`	Backplane for eight 2.5-inch hot-swap drives	√
`33`	Backplane for four 3.5-inch hot-swap drives	√
`34`	Simple-swap drive backplate assembly	√
`35`	Memory module (DCPMM module might look slightly from the illustration)	√
`36`	Processor		√
`37`	Heat sink		√

Give documentation feedback