Skip to main content

Install the LOM adapter

Use this information to install the LOM adapter.

Read the installation GuidelinesPower off the server for this taskATTENTION: Static Sensitive Device Ground package before opening
Before installing the LOM adapter:

  1. If riser 1 assembly is installed, remove it to access the LOM adapter slot.

  2. Touch the static-protective package that contains the new LOM adapter to any unpainted surface on the outside of the server. Then, take the new LOM adapter out of the package and place it on a static-protective surface.

To install the LOM adapter, complete the following steps:

Watch the procedure

A video of this procedure is available at YouTube.

Figure 1. LOM adapter installation
LOM adapter installation

  1. Insert the LOM adapter into the rear of the chassis at an angle as shown.
  2. Lower the LOM adapter and slide it to the rear of the chassis until the LOM adapter stops.
  3. Push the LOM adapter as shown to insert it into the connector on the system board.
  4. Tighten the thumbscrew to secure the LOM adapter.

After installing the LOM adapter, complete the parts replacement. See Complete the parts replacement.