Top view

This section contains information on the top view of the server.

Note

Depending on the configuration, your server might be slightly different from the image.

Refer to the following top view for different configurations

Top view for standard configurations

The following top view is based on typical 2.5'' drive configurations.

Figure 1. Server top view for standard configurations

Table 1. Component identification (Top view for standard configurations)
`1` Front backplane	`2` RAID flash power module
`3` Intrusion switch	`4` Fan modules
`5` Memory modules	`6` Processor and heat sink
`7` Riser assemblies^{note 1}	`8` Power supply units
`9` System board (system board assembly)	`10` Internal CFF HBA/RAID module

Note

The illustration shows the server rear configuration with 2 riser assemblies. The server rear configurations vary by server model. For details, see Rear view.

This following shows the top view of server models with the Liquid to Air Module (L2AM).

Figure 2. Server top view with the liquid to air module
Server top view for the liquid to air module

Table 2. Component identification (Top view with the L2AM)
`1` Radiator	`2` Cold plate assembly
`3` Leak detection connector	`4` PSU air baffle
`5` Liquid detection sensor module	`6` Pump connector
`7` The holder for the radiator

This following shows the top view of server models with the Direct Water Cooling Module (DWCM).

Figure 3. Top view with the DWCM
Top view of the direct water cooling module

Table 3. Component identification (Top view with the DWCM)
`1` Outlet hose	`2` Inlet hose
`3` Hose holder	`4` The liquid detection sensor module
`5` Cold plate assembly

Give documentation feedback