Parts list

Identify each of the components that is available for your server with the parts list.

For more information about ordering parts:

1. Go to Lenovo Data Center Support and navigate to the support page for your server.

2. Click Parts.

3. Enter the serial number to view a listing of parts for your server.

It is highly recommended that you check the power summary data for your server using Lenovo Capacity Planner before purchasing any new parts.

Note

Depending on the model, your server might look slightly different from the illustration.

Figure 1. Server components

The parts listed in the following table are identified as one of the following:

• Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.

• Tier 2 customer replaceable unit (CRU): You may install a Tier 2 CRU yourself or request Lenovo to install it, at no additional charge, under the type of warranty service that is designated for your server.

• Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.

• Consumable and Structural parts: Purchase and replacement of consumable and structural parts (components, such as a filler or bezel) is your responsibility. If Lenovo acquires or installs a structural component at your request, you will be charged for the service.

Table 1. Parts list

Index	Description	Tier 1 CRU	Tier 2 CRU	FRU	Consumable and Structural part
For more information about ordering parts: Go to Lenovo Data Center Support and navigate to the support page for your server. Click Parts. Enter the serial number to view a listing of parts for your server.
1	Top cover	√
2	Riser bracket (low profile-low profile)	√
3	Riser bracket (low profile)	√
4	Riser bracket (low profile-full height)	√
5	PCIe adapter	√
6	External diagnostics handset	√
7	RAID flash power module holder (on chassis)	√
8	RAID flash power module	√
9	Power supply unit	√
10	Power supply unit air duct	√
11	Power supply unit filler				√
12	Front I/O module with diagnostics panel (1)	√
13	Front I/O module with diagnostics panel (2)	√
14	OCP module	√
15	Performance heat sink (T-shape)			√
16	2.5-inch drive bay filler				√
17	2.5-inch drive	√
18	10 x 2.5-inch front drive backplane (AnyBay)		√
19	Security bezel				√
20	Rack latch (right)	√
21	Rack latch (left)	√
22	Internal RAID adapter		√
23	Intrusion switch	√
24	System fan	√
25	Memory module	√
26	Processor			√
27	Fan board			√
28	CMOS battery				√
29	Liquid assisted cooling module			√
30	Processor board			√
31	PIB board			√
32	System I/O board			√
33	Firmware and RoT Security Module			√
34	Chassis			√
35	MicroSD card	√

• Power cords
  Several power cords are available, depending on the country and region where the server is installed.