Skip to main content

Remove a C1/C2 rearwall bracket (right)

Use this information to remove a C1/C2 rearwall on the right of the rear chassis.

About this task

Attention

  • Read Installation Guidelines to ensure that you work safely.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Touch the static-protective package that contains the new riser card to any unpainted surface on the outside of the server. Then, take the new riser card out of the package and place it on a static-protective surface.
  2. Remove a C1 rearwall bracket.
    Note
    The illustration shows removing a C1 rearwall bracket. The procedure is the same for removing the C2 rearwall bracket.
    Figure 1. C1 rearwall bracket removal
    C1 rearwall bracket removal

    1. Remove the four screws.
    2. Remove the bracket from the chassis in the direction as shown.

After you finish

  1. Remove or install a rear drive cage or riser assemblies. See

  2. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube