Skip to main content

Remove the 4 x 2.5-inch rear drive cage

Use this information to remove the 4 x 2.5-inch rear drive cage.

About this task

Attention
  1. Read Installation Guidelines to ensure that you work safely.

  2. Power off the server and disconnect all power cords for this task.

  3. Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Prepare your server.
    1. Remove the top cover. See Remove the top cover.

    2. Disconnect the cables from the rear drive cage.

    3. Remove all the installed drives and fillers (if any) from the drive bays. See Remove a hot-swap drive.

  2. Remove the 4 x 2.5-inch drive cage.
    Figure 1. Removing the rear 4 x 2.5-inch drive cage
    Removing the 4 x 2.5-inch rear drive cage

    1. Twist and pull out the blue plunger.

    2. Slide the drive cage towards the rear of the chassis to release it.

  3. If needed, remove the backplane from the drive cage. See Remove the middle or rear 2.5-inch-drive backplane.

After you finish

If you are instructed to return the old drive cage, follow all packaging instructions and use any packaging materials that are provided.