SXM GPU Model cable routing
Follow the instructions in this section to learn how to do cable routing forSXM GPU Model.
Identifying connectors
Go through the following sections to acquire necessary information before starting cable routing.
For the connectors on system board, see System-board connectors.
For the connectors on the drive backplane, front I/O expansion board, and retimer assembly, see Identifying connectors.
SXM GPU Model configurations
Cable routing is different by configuration. See the table below for the configuration that matches your server, and refer to the corresponding cable routing guide.
| Drive quantity | OCP Ethernet adapter | Configurations |
|---|---|---|
| Eight drives | Configuration F | |
| Four drives | V | Configuration G |
Refer to the corresponding cable routing guide:
For Configuration F, see Configuration F cable routing
For Configuration G, see Configuration G cable routing
Make sure to route the cables through cable guide and cable clip as instructed in the cable routing guides. See the illustration below for the cable guide and cable clip locations.
Figure 1. Cable guide and cable clip locations in the chassis
Give documentation feedback