Skip to main content

Install the intrusion switch

Follow instructions in this section to install the intrusion switch.

About this task

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

Install the intrusion switch.
  1. Push the intrusion switch into the intrusion switch bracket on top of the PSU bays. Make sure the intrusion switch is fully seated in the bracket.
  2. Route the intrusion switch cable through the three cable clips on the outside of the PSU bays.
  3. Connect the intrusion switch cable to the system board. See System-board connectors for intrusion switch connector location on system board.
    Figure 1. Installing the intrusion switch
    Installing the intrusion switch


    1 Intrusion switch connector

After you finish

  1. Reinstall the PCIe riser 2 if needed. See Install a PCIe riser.

  2. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube