Skip to main content

Network problems

Use this information to resolve issues related to networking.

Cannot wake server using Wake on LAN​

Complete the following steps until the problem is resolved:
  1. If you are using the dual-port network adapter and the server is connected to the network using Ethernet 5 connector, check the system-error log or XCC system event log (see Event logs), make sure:

    1. Fan 3 is running in standby mode, if Emulex dual port 10GBase-T embedded adapter is installed.

    2. The room temperature is not too high (see Specifications).

    3. The air vents are not blocked.

    4. The air baffle is installed securely.

  2. Reseat the dual-port network adapter.

  3. Turn off the server and disconnect it from the power source; then, wait 10 seconds before restarting the server.

  4. If the problem still remains, replace the dual-port network adapter.

Could not log in using LDAP account with SSL enabled​

Complete the following steps until the problem is resolved:

  1. Make sure that the license key is valid.

  2. Generate a new license key and log in again.