Skip to main content

Disassemble the 2U compute shuttle

Follow the instructions in this section to disassemble the 2U compute shuttle before recycling.

About this task

Refer to local environmental, waste or disposal regulations to ensure compliance.

Procedure

  1. Remove the 2U compute shuttle. See Remove the 2U compute shuttle.
  2. Remove the processor air baffle. See Remove the processor air baffle.
  3. Remove the rear PCIe switch cable harness. See Remove the rear PCIe switch cable harness.
  4. If applicable, remove the PCIe riser assembly(ies). See Remove a PCIe riser assembly.
  5. If applicable, remove the system I/O board. See Remove the system I/O board.
  6. Remove all the processors and the heat sinks. See Remove a processor and heat sink.
  7. Remove all the memory modules. See Remove a memory module.
  8. Remove the CMOS battery (CR2032). See Remove the CMOS battery (CR2032).
  9. Remove the system board. See Remove the system board.

After you finish

After disassembling the 2U compute shuttle, recycle the unit in compliance with local regulations.