Skip to main content

Install a flash power module

Follow instructions in this section to install a flash power module.

About this task

Note
Figure 1. Available flash power module slots for 9350-8i and 9350-16i RAID adapters

When 9350-8i or 9350-16i RAID adapter is installed, only the middle two slots are available for flash power module. Make sure to install the flash power module into these two slots.
Attention
  • Go over Installation Guidelines to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Press on the retaining latch; then, align the flash power module with the slot in the PCIe expansion tray, and push it in.
    Figure 2. Installing the flash power module

  2. Connect the cable to the RAID adapter. Make sure to route the cable through the cable clips on the PCIe expansion tray.
    Figure 3. Connecting the cable to the RAID adapter

After this task is completed

Proceed to complete the parts replacement (see Complete the parts replacement).