Remove the hot-swap power supply cage

Use this information to remove the hot-swap power supply cage.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

Before removing the hot-swap power supply cage:

1. If the server is installed in a rack, extend the server from the rack.

2. Remove the server cover. See Remove the server cover.

3. Remove the air baffle. See Remove the air baffle.

4. Remove the hot-swap power supplies. See Remove a hot-swap power supply.

5. Remove the power interface board. See Remove the power interface board.

To remove the hot-swap power supply cage, complete the following steps:

Figure 1. Hot-swap power supply cage removal

1. Remove the screws that secure the hot-swap power supply cage.
2. Push the hot-swap power supply cage toward the front of the server. Then, remove the hot-swap power supply cage out of the chassis.