Skip to main content

Setting the shelf ID with the ODP push button

You can set or change the shelf ID for a controller shelf or a drive shelf by using the ODP push button.

Before you begin

Each controller shelf or drive shelf has LEDs located on the operator display panel (ODP). You might need to remove the left end cap to see the ODP push button. The controller shelf or drive shelf must be powered on before you begin this task.

The following figure shows the ODP push button on controller shelf and drive shelf with 12 drives.
Figure 1. ODP push button on controller shelf and drive shelf with 12 drives

The following figure shows the ODP push button on controller shelf and drive shelf with 24 drives.
Figure 2. ODP push button on controller shelf and drive shelf with 24 drives
ODP push button on controller shelf and drive shelf with 24 drives
1ODP push button
The following figure shows the ODP push button on controller shelf and drive shelf with 60 drives.
Figure 3. ODP push button on controller shelf and drive shelf with 60 drives
ODP push button on controller shelf and drive shelf with 60 drives
1ODP push button
  1. Press and hold the push button until the first number on the seven-segment display starts to blink.
    It might take up to three seconds for the number to blink. If the number does not blink in this time, release the button and press it again. Make sure to press the button all the way in.
  2. Change the first number of the shelf ID by repeatedly pressing the push button to advance the number until you reach the desired number from 0 to 9.
    The first number continues to blink.
  3. Press and hold the button until the second number on the digital display starts to blink.
    It might take up to three seconds for the second number to blink. The first number on the seven-segment display stops blinking.
  4. Change the second number of the shelf ID by repeatedly pressing the button to advance the number until you reach the desired number from 0 to 9.
    The second number continues to blink.
  5. Lock in the desired number, and exit the programming mode by pressing and holding the button until the second number stops blinking.
    It might take up to three seconds for the second number to stop blinking.