Removing and replacing Tier 1 customer replaceable units (CRUs)
Use this information for removing and replacing Tier 1 CRUs.
Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request, you will be charged for the installation.
- Removing the adapter-retention assembly
Use this information to remove the adapter-retention assembly. - Installing the adapter-retention assembly
Use this information to install the adapter-retention assembly. - Removing the bezel
Use this information to remove the bezel. - Installing the bezel
Use this information to install the bezel. - Removing the ID label plate
Use this information to remove the identification (ID) label plate from the front panel. - Installing the ID label plate
Use this information to install the identification (ID) label plate on the front panel. - Removing the CMOS battery
Use this information to remove the CMOS battery. - Installing the CMOS battery
Use this information to install a CMOS battery. - Removing a DIMM
Use this information to remove a dual inline memory module (DIMM). - Installing a DIMM
Use this information to install a DIMM. - Removing a hard disk drive backplane
Use this information to remove a hard disk drive backplane. - Installing a hard disk drive backplane
Use this information to install a hard disk drive backplane. - Removing a hot-swap hard disk drive
Use this information to remove a hot-swap hard disk drive. - Installing a hot-swap hard disk drive
Use this information to install a hot-swap hard disk drive. - Removing a solid state drive mounting sleeve
Use this information to remove an optional solid state drive mounting sleeve. - Installing a solid state drive mounting sleeve
Use this information to install an optional solid state drive mounting sleeve. - Removing a 1.8-inch solid state drive
Use this information to remove a 1.8-inch hot-swap solid state drive (SSD). Solid state drives can be installed in the compute node, only if an SSD enablement kit is installed. - Installing a 1.8-inch solid state drive
Use this information to install a 1.8-inch hot-swap solid state drive (SSD). Solid state drives can be installed in both the upper and lower compute nodes, if an SSD mounting sleeve is installed. - Removing a ServeRAID M5215 controller
Use this information to remove a ServeRAID M5215 controller. - Installing a ServeRAID M5215 controller
Use this information to install a ServeRAID M5215 controller. - Removing an interposer cable
Use this information to remove an interposer cable. - Installing an interposer cable
Use this information to install an interposer cable. - Removing an I/O expansion adapter
Use this information to remove an I/O expansion adapter. - Installing an I/O expansion adapter
Use this information to install an I/O expansion adapter. - Removing the RFID tag
Use this information to remove the RFID tag from the front panel. - Installing the RFID tag
Use this information to install the RFID tag on the front panel. - Removing the SD Media Adapter for System x
Use this information to remove an optional SD Media Adapter for System x (Adapter for SD Media or SD adapter). - Installing the SD Media Adapter for System x
Use this information to install an optional SD Media Adapter for System x (Adapter for SD Media or SD adapter). - Removing an SD card
Use this information to remove an SD card. - Installing an SD card
Use this information to install an SD card.
Give documentation feedback