Skip to main content

Installing the battery holder into 5U server model

Use this information to install the battery holder into 5U server model

Attention
To ensure proper cooling and airflow, do not operate the server for more than 30 minutes with the side cover removed.

To install the battery holder into 5U server models with hot-swap power supplies, complete the following steps.

  1. Read the safety information in Safety and Installation guidelines.
  2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
  3. Unlock and remove the side cover (see Removing the side cover).
  4. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
    Attention
    Do not allow the server to fall over.

  5. Attach the latch retainer onto the battery holder.

    Figure 1. Latch retainer attachment onto battery holder for 5U server models with hot-swap power supplies
    Latch retainer attachment onto battery holder for 5U server models with hot-swap power supplies
  6. Insert the battery holder into the bracket.
    Figure 2. Battery holder insertion into bracket for 5U server models with hot-swap power supplies
    Battery holder insertion into bracket for 5U server models with hot-swap power supplies
  7. Tighten the screw to secure the battery holder and bracket to the chassis.
    Figure 3. Securing battery holder to chassis for 5U server models with hot-swap power supplies
    Securing battery holder to chassis for 5U server models with hot-swap power supplies
  8. If you have other devices to install, do so now. Otherwise, go to Completing the installation.