Skip to main content

Removing the bezel

This procedure applies only to 4U server models with non-hot-swap power supplies.

When you work with some devices on 4U server models with non-hot-swap power supplies, such as the drives in bays 3 through 6, you must first remove the bezel to access the devices.

  1. Read the safety information in Safety and Installation guidelines.
  2. Press the button on the left edge of the bezel; then, rotate the left side of the bezel away from the server until it disengages and set it aside.
    Note
    When rotating the bezel to a certain point, it may automatically disengage from the chassis.
    Figure 1. Bezel removal for 4U server model with non-hot-swap power supplies (1)
    Bezel removal for 4U server model with non-hot-swap power supplies (1)
    Figure 2. Bezel removal for 4U server model with non-hot-swap power supplies (2)
    Bezel removal for 4U server model with non-hot-swap power supplies (2)
  3. If you are instructed to return the bezel, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.