Removing and replacing Tier 1 CRUs
This section provides information for removing and replacing Tier 1 CRUs in the server.
Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
- Removing and installing internal drives
Use this information to remove and install internal drives. - Removing the hard disk drive fan duct
This procedure applies only to the 5U server model with hot-swap power supplies. - Replacing the hard disk drive fan duct
This procedure applies only to the 5U server model with hot-swap power supplies. - Removing the USB embedded hypervisor flash device
Use this information to remove the USB embedded hypervisor flash device. - Replacing the USB embedded hypervisor flash device
Use this information to replace a USB embedded hypervisor flash device. - Removing the simple-swap backplate
This procedure applies only to 4U server models with non-hot-swap power supplies. - Replacing the simple-swap backplate
This procedure applies only to 4U server models with non-hot-swap power supplies. - Replacing software RAID simple-swap hard disk drive backplate with hardware RAID simple-swap hard disk drive backplate
This procedure applies only to 4U server models with non-hot-swap power supplies. - Removing the hot-swap hard disk drive backplane
This procedure applies only to the 5U server model with hot-swap power supplies. - Replacing the hot-swap hard disk drive backplane
This procedure applies only to the 5U server model with hot-swap power supplies. - Removing the operator information panel assembly
Use this information to remove the operator information panel assembly - Replacing the operator information panel assembly
Use this information to replace the operator information panel assembly - Removing the front USB connector assembly
Use this information to remove the front USB connector assembly - Replacing the front USB connector assembly
Use this information to replace the front USB connector assembly - Removing the rear adapter retention bracket
This procedure applies only to the 5U server model with hot-swap power supplies. - Replacing the rear adapter retention bracket
This procedure applies only to the 5U server model with hot-swap power supplies. - Removing the non-hot-swap power supply
This procedure applies only to 4U server models with non-hot-swap power supplies. - Replacing the non-hot-swap power supply
This procedure applies only to 4U server models with non-hot-swap power supplies. - Removing the hot-swap power supply
This procedure applies only to the 5U server model with hot-swap power supplies. - Replacing the hot-swap power supply
This procedure applies only to the 5U server model with hot-swap power supplies. - Removing an adapter
Use this information to remove an adapter - Replacing an adapter
Use this information to replace an adapter - Removing a memory module
Use this information to remove a memory module. - Replacing a memory module
Use this information to replace a memory module - Removing the system battery
Use this information to remove a system battery. - Replacing the system battery
Use this information to replace the system battery - Removing the rear system fan
This procedure applies only to 4U server models with non-hot-swap power supplies. - Replacing the rear system fan
This procedure applies only to 4U server models with non-hot-swap power supplies. - Removing the thermal solution fan kit
Use this information to remove the thermal solution fan kit - Replacing the thermal solution fan kit
Use this information to replace the thermal solution fan kit - Removing the operating temperature enhancement kit
Use this information to remove the operating temperature enhancement kit - Replacing the operating temperature enhancement kit
Use this information to replace the operating temperature enhancement kit
Give documentation feedback