Replacing the hot-swap hard disk drive backplane

To install the hard disk drive backplane on the 5U server model with hot-swap power supplies, complete the following steps.

1. Read the safety information in Safety and Installation guidelines.
2. Place the bottom edge of the hot-swap hard disk drive backplane in the lower lip of the drive cage.
3. Connect the power, signal and configuration cables to the hard disk drive backplane.
   Note

   Make sure that Port 1 on the hardware ServeRAID is connected to Port 1 on the backplane. Likewise, Port 0 on the hardware ServeRAID should be connected to Port 0 on the backplane.

   The following illustration is for 5U server models with 2.5" hot swap hard disk drives installed.

   Figure 1. 2.5" hot swap hard disk drive backplane cabling installation for 5U server model with hot-swap power supplies
   
   

   The following illustration is for 5U server models with 3.5" hot swap hard disk drives installed.

   Figure 2. 3.5" hot swap hard disk drive backplane cabling installation for 5U server model with hot-swap power supplies
   
   
4. Install the screws that secure the hot-swap hard disk drive backplane to the drive cage.
   Note

   • A total of four screws need to be installed for backplanes that support 2.5" hot-swap hard disk drives.
   • A total of two screws need to be installed for backplanes that support 3.5" hot-swap hard disk drives.

   The following illustration is for 5U server models with 2.5" hot swap hard disk drives installed.

   Figure 3. 2.5" hot swap hard disk drive backplane screw installation for 5U server model with hot-swap power supplies
   
   

   The following illustration is for 5U server models with 3.5" hot swap hard disk drives installed.

   Figure 4. 3.5" hot swap hard disk drive backplane screw installation for 5U server model with hot-swap power supplies
   
   
5. Press and hold the retaining tab on the side of the cage; then, rotate the drive cage into the chassis until it locks into place.
   Note

   You may need to slightly lift up the cage in order to press and hold the retaining tab.
   Figure 5. Rotating hard disk drive cage into chassis for 5U server model with hot-swap power supplies
   
   
6. Install the hard disk drive fan duct onto the hard disk drive cage (see Replacing the hard disk drive fan duct).
7. Stand the server back up in its vertical position.
8. Install the hot-swap hard disk drives that you removed from the hard disk drive cage (see Replacing a hot-swap hard disk drive).
9. Install the lower bezel (see Replacing the lower bezel).
10. Install and lock the side cover (see Replacing the side cover).
11. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.