Skip to main content

W.50001 : [W.50001]


A DIMM has been disabled due to an error detected during POST. DIMM Disabled



User Response

Complete the following steps:

  1. If the DIMM was disabled because of a memory fault, follow the procedure for that event.
  2. If no memory fault is recorded in the logs and no DIMM connector error LEDs are lit, re-enable the DIMM through the Setup utility or onecli Utility.
  3. If the problem persists, Power cycle the compute node from the management console.
  4. Reset the IMM to default settings.
  5. Reset UEFI to default settings.
  6. Update IMM and UEFI firmware.
  7. Replace the system board.