Skip to main content

Replacing the stabilizing feet

Use this information to replace the stabilizing feet.

To replace the server stabilizing feet, complete the following steps:

  1. Read the safety information that begins in Safety and Installation guidelines.
  2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
  3. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
    Attention
    Do not allow the server to fall over.
  4. Carefully position the server on a flat surface, with the feet hanging over the edge of the flat surface to ease removal.
  5. Press in on the clips that hold the feet in place; then, remove the feet away from the server. In some cases, you might need a screwdriver to press in on the clips.


  6. To reinstall the feet in the location, push the clips of the feet into the right place of the server.